I'm a small-time blacksmith and have, for a long time, relied on my trusty grinder with cutting disks for all my metal cutting needs. I decided to invest in better tools for cutting metal and after a lot of research, decided on Evolution. I purchased the 380CPS chop saw with stand, for bar and round stock cutting, and the 210CCS circular saw for sheet cutting. It's a little early for me to comment on the longevity of these tools but I can comment on early usage and the customer service I've received. I ran into a problem with the chop-saw cutting 3/16 round. I'm not sure how to avoid this problem in the future, other than not cutting small round with the chop saw, but the issue was the blade grabbed the round and pulled it into the saw guard instead of cutting it. The vise was as tight as I could get it so I don't believe that was the issue but regardless, the 3/16 round bar wrapped around the drive shaft like spaghetti, tore out some internal stops and bent the blade. I called their support line and customer service couldn't have been better. I explained the issue and took some pictures. They asked me to send it back with a pre-paid FedEx label and within the same day they received it, they sent me a new one. I literally could not ask for better customer service. The 210CCS circular saw is like a dream cutting 16 guage sheet. I fabricated some new panels for my rusting grill and it was so much faster and easier than using my grinder. Overall, I'm very happy with the purchase and if Evolution can keep their customer services levels up to the level they are currently, feel they'll be a trusted brand to contend with for a long time.