Although the design of the Rage 5 Table saw is very good, the actual assembly was terrible. There is no way in this world that my Saw was checked on assembly due to the fact that the sliding table was almost 1 mm below the main table at 1 end and was scraping on the underside and catching on screws inserted crookedly. The Orange hand wheel which locates on to the geared rack for blade adjustment could not be located due to the plastic frame of the saw being 4 mm too high, i had to cut the plastic away so as to get the wheel to push in. The Rip fence, even with the 2 screws slackened off and moved from side to side would not line up with the blade i had to strip it down and adjust it. I am an ex engineer, and was able to work on it, and I needed the saw as soon as possible Otherwise i would have returned it, but i corrected it myself. Its a pity i needed to put in a poor review because this table saw design has the potential to be one of the best. I found home assembly quite straight forward, so maybe a couple of minor mods and a definite inspection would suffice.