For the price this is an excellent piece of kit and I am very impressed with it. On opening, 1 plastic end cap was missing. This was reported to Evolution and the parts arrived in the post next day - Excellent customer service. In the booklet, the leg assembly drawings are not the easiest to follow and I was second guessing which way round to put things but there are plenty of YouTube videos available to help if needed. Accuracy out of the box was pretty good - blade vertical vertical to saw bed was 89.9 degrees. Rip fence varied a bit - move it from right to left and lock it and it is 0.5mm out of square with the blade. Move it from left to right and it is 1mm out of square. Tape is only a guide and what you see depends on the right side extension position. Mitre gauge is solid but plastic and needs an angle gauge to set it accurately. Two let downs. Firstly when you switch it on there is no soft start. This saw jumps on startup and would benefit from soft start. I have seen a German YouTube video of a Polish soft start unit being fitted retrospectively. So could Evolution could offer an upgrade kit to do this? Secondly (rain stopped play and I need to play around a bit more with the riving knife) out of the box I tried cutting 18mm ply with the blade poking through by about 2mm, The gap under the back of the safety guard was only about 6mm so the material would not pass through without raising the blade significantly. The riving Knife needs to be raised for this to work. Nobody on YouTube mentioned this and I can't see much in the book either so perhaps it is normal to do this and just my inexperience showing through. Overall I am very impressed and managed to trim a consistent 0.5mm from a 6 inch wide 8ft length of 18mm ply. My old saw couldn't cut a straight line in a 6 inch length of 1 x 4 so this is almost miraculous compared to what I am used to.