Just bought the Rage5S table saw to use at home and on sight. I am an avid woodworker and carpenter. The saw is perfect for use onsite where exactness is not an issue. The saw does cut accurately but the table is made from aluminum. For fine cuts I would prefer a cast iron top but it does a good enough job if you don't mind a bit of sanding. Setup was straight forward and was in pretty good shape out of the box. The rip fence is good and solid. The main issue I have is with the throat plate. You might as well throw it away. It is made from 3mm plastic and is very flimsy. It flexes approximately 3-4mm when you put pressure on it. Since it is only has a 3mm recess, it is hard to find a material that won't flex. I used perspex with strips of 12mm ply to reinforce it. The worst throat plate I have ever seen.