Original Evolution box shipped all the way to my location in Hong Kong a bit banged up but don't appeared to be serious enough to damage the machine. However, initial setting up checking squareness, level, and flatness reveals the mitre turntable sticks up so much that an approximately 1 mm gap appears on all sides rocking the straight edge left and right, and actually front and back as well! This is partly due to a crowned mitre turntable, but I have also discovered that the whole mitre table sits almost 1 mm above the flat top on either sides!! These uneven surfaces combined is probably the total surface grinding they have neglected to perform at the factory. This is likely the result of corner-cutting manufacturing practice and poor QC, hurriedly putting the machine together to ship, therefore ruining a minimal level of accuracy for what might be, a well-designed machine that I have yet to use.... Full of great expectation but very disappointed as you can imagine.